|
|
 |
Parabeam 700-fsk swivel
brackets are already fitted
but you may need change the position of the fixing bracket depending
on the surface you want to mount the enclosure to. |
Solar panel wires are also
pre-connected. If the cable requires shortening or lengthening, the
wires should be reconnected and routed as shown in the diagram.
The internal battery is installed but
NOT connected on
arrival and should be connected prior to the alignment test.
|
|
 |
 |
The
wireless security beam is mounted at hip height to be able to detect people
and
vehicles but ignore small animals, flying birds and peripheral
movement.
The beam emitter can be adjusted to produce the beam length -
up to 10m, up to 25m and up to 40m.
Mount the security beam emitter and communicator (the one with the antenna)
so the they are visually straight and squarely facing each other.
|
The solar panel swivel bracket is
already fitted and 5m of weatherproof cable attached.
It is important to find a position which allows the panel to face
flat up to open sky and avoid shading on any side.
The cable may be lengthened by another 10m if needed to gain the
best position.
|
|
 |
 |
Connect the batteries to the socket on the circuit board and
re-fit the
front covers.
Alignment is simple. From the left side of the communicator,
gradually cover the beam window until the yellow LED flashes which
signifies the beam is broken. Do the same from the right side of the
window and compare the positions at which the yellow LED flashes. If
it's roughly
the same you're done! |
Attach the Base receiver's antenna as
per manual.
Plug in the receiver's mains adapter and switch on.
The beam/s is pre-coded to the base receiver and immediately ready
for use.
Pass through the beam to test.
|
